TESY HL-274W PTC, Инструкции по использованию и хранению

Страница: 4 / 72

4
Usage and Storage Instructions
EN
INSTALLATION
The heater must be mounted on a wall before usage.
Your appliance shall be used only in fixed position and
shall be installed at least at 1.80m from the ground
and at least 25 сm from both corners of the wall and
a minimum distance of 60cm from the ceiling. Do not
install/place the appliance on the floor. (Respect the
installation rules given below).
The sequence of mounting the appliance is as follows:
•
Select the place for installation while observing the
requirements described in the beginning of the
manual.
39,8 cm
8
39,8 cm
8
•
Drill 2 holes of ø8 mm in the wall, at a height of 1.8
m and at a distance of 39.8 cm from each other.
Make sure the diameter of the holes is identical to
the one of the plastic wall plug.
•
Place and screw the two screws into the wall plugs
but leave the screw heads projecting out at 15 mm.
Make sure the screws are steadily attached to the
wall and mount the appliance.
FUNCTION INSTRUCTION
Remote control
OK
DAY
TIME
/ON
EDIT
TIME
/OFF
SET
P
Program area
Adjust & confirm area
Regular function area
Function operation (both machine & remote control)
OK
DAY
TIME
/ON
EDIT
TIME
/OFF
SET
P
C I
II
P
1. Plug in and switch on by pressing the red switch 0/I,
enter into standby mode and display shows“S”
C I
II
P
2. Press , button, enter into fan mode and display
shows „- -“
C I
II
P
3. Press , button for one time, the product works
with low heating(1000W) and display shows“-- / I”.
Press again, changes to high heating (2000W) and
display shows “ -- / I / II”.