4
Usage and Storage Instructions
EN
EN
•
Discard the collected water
Note
1. Do not remove the float from the water tank. The
water full sensor will no longer be able to detect
the water level correctly without the float and water
may leak from the water tank.
2. If the drainage tank is dirty, wash it with cold or
lukewarm water. Do not use detergent, scouring
pads, chemically treated dust cloths, gasoline,
benzene, thinner, or other solvents, as these can
scratch and damage the tank and cause water
leakage .
3. When replacing the drainage tank, press the tank
firmly into place with both hands. If the tank is not
positioned properly, the “TANK FULL” sensor will be
activated, and the dehumidifier will not operate.
Continuous Water Drainage
The unit features a continuous drainage port .Using a
plastic pipe (with an inner diameter of 10mm) inserts into
drain hole (on intermediate plate), reach out from side of
water tank, install it in place, and arrange the drain pipe.
The water in the drainage tank can be continuously
drained out from the continuous port on the unit.
MAINTENANCE
Cleaning the Dehumidifier:
To clean the Body - Wipe it with a soft damp cloth.
To Clean the Air Filter
1. Open the inlet grill firstly and remove the air filter.
2. Clean the air filter.
Run a vacuum cleaner lightly over the surface of the air
filter to remove dirt. If the air filter is exceptionally dirty,
wash it with warm water and a mild cleanser and dry
thoroughly.
3. Attach the air filter.
Insert the filter into the grill smoothly, and place the
inlet grill into right place.
