TESY 10044, Приложение

Страница: 3 / 28

Appendix to instruction for use and maintenance
3
EN
English
Special features concerning the water heater with
two heat exchangers and a thermal sensor pocket are
described in this appendix.
The Base instruction manual is valid for water heaters
with two heat exchangers and a thermal sensor pocket,
except the following: Addition to paragraph VIII – “models
equipped with a heat exchanger (serpentine tube) ”
Models with two heat exchangers and a thermal sensor
pocket
The installation of the unit is at the buyer’s expense and
must be carried out by a professional technical person
in accordance with instructions in the manual.
Technical parameters:
Type GCV7/4S
10044
GCV7/4S
12044
GCV7/4S
15044
Surface of serpentine S1 (m²) 0.5 0.5 0.5
Surface of serpentine S2 (m²) 0.3 0.3 0.3
Volume of serpentine S1 (l) 2.4 2.4 2.4
Volume of serpentine S2 (l) 1.4 1.4 1.4
Operational pressure of
serpentine S1 (MPa)
0.6 0.6 0.6
Operational pressure of
serpentine S2 (MPa)
0.6 0.6 0.6
Maximum temperature of
heat carrier (°C)
80 80 80
These models allow for connection to two external heat sources
– a solar panel and local or central water heating supply.
Serpentine markings:
•
S1 and an arrow pointing at the serpentine lead-in –
inlet of serpentine S1
•
S1 and an arrow pointing outwards from the serpentine
lead-in – outlet of serpentine S1
•
S2 and an arrow pointing at the serpentine lead – inlet
of serpentine S2
•
S2 and an arrow pointing outwards from the serpentine
lead-in – outlet of serpentine S2
There is a connexion with internal thread of ½” welded
to the water tank for the purposes of installing thermal
probe – marked with „TS”. The appliance is fitted with brass
pocket for a thermal probe which should be screwed into
the aforesaid connexion.
See fig. 1:
Dimensions, mm [±5]
Type
GCV7/4S
10044
GCV7/4S
12044
GCV7/4S
15044
A 927 1137 1302
440 440
338
428
518 642 740 240
fig. 1