International Electronic/Service Vacuum
Operating Instructions
3
To Operate
Step 1
Release latches
and open lid.
Step 2
Unfasten accessory
door and remove vacuum
hose, electrical cord and
hose attachments.
Step 3
Remove filter plug from
vacuum inlet (always
replace when repacking for
transport).
Step 4
Attach selected
accessory to hose (insert
crevice brush as shown).
Insert other end of hose
into inlet.
Step 5
Place remaining accessory and
filter plug in lid. Close lid.
Step 8
Plug cord into
power receptacle.
Step 9
Turn on power switch.
Step 6
Latch lid securely.
Step 7
Insert hooded end
of power cord in power
cord receptacle on
vacuum as shown.
Follow the steps in the illustration.
DO NOT OPERATE WHEN FILTER
IS FULL. A lack of exhaust air, or
diminished suction, indicates a full filter.
ELECTRIC SHOCK COULD
OCCUR IF USED OUTDOORS
OR ON WET SURFACES.
1. Release the latches and open the lid.
2. Unfasten the accessory door and
remove the vacuum hose, electrical
cord and hose attachments.
3. Remove the L-15X filter plug from
the vacuum inlet (always replace when
the vacuum is not in use or repacking
for transport).
4. Attach the selected accessory to the
hose (insert the crevice brush as
shown). Insert the hose into the inlet.
5. Place the other accessories and plug in
the lid. Close the lid.
6. Latch the lid securely.
7. Plug the cord into the vacuum.
8. Plug the cord into the power
receptacle.
9. Turn on the power switch.
Note
The motor has a thermal breaker that
opens and stops the motor if it
overheats. This usually occurs if the
filter is full and needs to be replaced.
The motor will restart automatically
when it cools (after about 30 minutes).
WARNING
!
