TI4200 GPU-24-PFC
22
Section 4 – Post Operation
4.1 – General
Although the TI4200 GPU-24-PFC has been ruggedized and made weather resistant within the scope of unit’s
intended use, it is essential that good general care be taken to maintain unit in good operating condition and
to maximize unit’s operational life.
4.2 – After Use
Unit should be protected from environmental elements and man made hazards. Ideally unit should be secured
in a building or shed. Most importantly, unit shall be fully covered if stored while exposed to environmental
elements.
4.3 – Power Cell Recharge
NOTE
!
The TI4200 GPU-24-PFC incorporates a backcharge feature that enables
the unit to be recharged from the vehicle once the engine is started and
the starter/generator is running. This feature will enable you to start
multiple vehicles without reconnecting to ac power if the GPU is allowed to
backcharge for approximately 30 seconds.
NOTE
!
Plug the TI4200 GPU-24-PFC into ac power to keep the cells charged
whenever it is not in use, even if it is at Full Charge. The unit will not
overcharge or overheat.
Connect AC Power Cord to Unit
Ensure power cord is properly connected to an approved ac power supply. After approximately 5-8 seconds,
ensure unit’s LED status indicator illuminates indicating power cell state of charge and cooling fan is
operating.
Any time the unit’s power cells are fully discharged the unit shall be recharged within 24 hours to prevent
performance degradation and ensure maximum life.
Figure 4.3.1 Connecting TI4200 GPU-24-PFC to AC Power Supply