BEFORE FIRST USE
Remove all packaging material, appliance and accessories. Remove any transparencies, stickers, or
paper. Check that the appliance and any part of it is not damaged.
WARNING: Before carrying out any of the following operations, make sure that the appliance is
switched off, unplugged and contains little or no water.
Locking the handle in position/releasing the handle
To lock the handle to a vertical position, simply lift the handle until it clicks into place. Check the
handle before using the steam mop. To release the handle and fold the appliance for storage, press
the release button (3) on the handle and then gently lower the handle.
Attach the base to the main body until it clicks into place. The steam head can be removed from the
main body of the appliance by pressing the release button on the back of the main body of the
appliance. Then simply push the microfiber mop onto the bottom of the base.
Connecting the glider to the carpet
For easier movement of the steam mop on the carpet, we recommend attaching the plastic glider to
the carpet. After attaching the microfiber mop, place the white plastic carpet glider on a flat surface
with the open side facing up. The steam mop simply snaps into place by pushing into the glider. To
remove the glider, carefully release the securing clips and the carpet glider will release.
FILLING THE WATER TANK
1st method of filling
Open the lid of the water tank and fill it with a plastic water measuring cup. Replace the cap and close
it by turning it clockwise.
2nd method of filling
Remove the water tank from the main body by pressing the buttons on the side (8). Open the lid of the
tank and pour water directly into it from the tap. Then replace the cap and close it by turning it
clockwise. Insert the tray back into the main body until it clicks into place.
Do not add any cleaning agents, chemicals or perfume to the Water tank. To significantly reduce the
formation of limescale and prolong the life of your steam mop, we recommend using distilled water
for cleaning. NEVER overfill the water tank.
FLOOR CLEANING
Connect the appliance to a grounded socket.
1.
When the appliance is switched on, a red light comes on under the water tank (on the sides),
which means preheating.
2.
Preheating takes approximately 20 seconds. When the steam mop is ready for use, the light
turns blue and automatically releases steam. For this reason, it is important not to leave it
unattended during the preheating process.
3.
When cleaning a surface contaminated with grease, oil, etc., it is also possible to add a cleaning
agent to the hot steam. Open the Cleaning solution container cap (11), pour the cleaning solution
into it, and then close the cleaning solution tank again. Press the cleaning solution drain button
(10) to the ON position.
4.
The amount of steam discharged can be adjusted using the rotary knob of Steam discharge rate
Содержание SteamPower FX30
Страница 1: ...TESLA SteamPower FX30...