Tesla RD2100M, Руководство пользователя

Страница: 7 / 44

7
ENG
TROUBLESHOOTING
The following simple issues can be handled by the user. Please call the after-sale service department if the issues are not settled.
Inoperation
Whether the freezer is plugged and connected to power; Low
voltage;
Failure power or tripping circuit
Odor
Odorous foods should closely wrapped;
Whether foods are rotten;
Whether the interior shall be cleaned.
Long-term operation of compressor
It is normal that refrigerator operates for longer time in summer
when the ambient temperature is higher;
Do not put too much food in the freezer at one time;
Do not put foods until they are cooled;
Frequent opening of refrigerator door.
Illuminating light does not shine
Whether the refrigerator is connected to power,
whether the illuminating light is damaged
The refrigerator door cannot be properlyclosed.
The freezer door is stuck by food packages;
Too much food;
Tilt refrigerator.
Loud noises
Whether the food is leveled, whether the refrigerator is balanced;
Whether the refrigerator parts are properly placed.
Tips
• The refrigerator enclosure may emit heat during operation
specially in summer, this is caused by the radiation of the
condenser, and it is a normal phenomenon.
• Condensation: condensation phenomenon will be
detected on the exterior surface and door seals of the
freezer when the ambient humidity is large, this is a normal
phenomenon, and the condensation can be wiped away
with a dry towel.
• Buzz: Buzz will be generated by running compressor
specially when starting up or shutting down.
TIPS FOR ENERGY SAVING
Try not to open the door too often, especially when the
weather is wet and hot. Once you open the door, close it as
soon as possible.
Every now and then check if the appliance is sufficiently
ventilated (adequate air circulation behind the appliance).
In normal temperature conditions, please arrange the
thermostat at the middle setting.
Before loading the appliance with packages of fresh food,
make sure they are cooled to ambient temperature.
Ice and frost layer increase energy consumption, so clean the
appliance as soon as the layer is 3-5 mm thick.
If it is the outer condenser, the rear wall should be always
clean free of dust or any impurities.
• The appliance should be located in the coolest area of the
room, away from heat producing appliances or heating
ducts, and out of the direct sunlight.
• Let hot foods cool to room temperature before placing
in the appliance. Overloading the appliance forces the
compressor to run longer. Foods that freeze too slowly may
lose quality, or spoil.
• Be sure to wrap foods properly, and wipe containers dry
before placing them in the appliance. This cuts down on
frost build-up inside the appliance.
• Appliance storage bin should not be lined with aluminum
foil, wax paper, or paper toweling. Liners interfere with cold
air circulation, making the appliance less efficient.
• Organize and label food to reduce door openings and
extended searches. Remove as many items as
needed at one time, and close the door as soon as
possible.