Tools and Materials Required
Before installing the Wall Connector, gather the following tools and materials:
•
Pencil or marker
•
Hole punch (optional, to push through cardboard template)
•
Wire stripper
•
Voltmeter or digital multimeter (to measure AC voltage at the installation site)
•
Phillips screwdriver
•
Small flathead screwdriver
•
Large flathead screwdriver (optional, to remove plastic knock-outs)
•
T20 security pin Torx driver
•
T10 Torx driver
•
M20 and M32 cable glands (also known as sealing hubs)
•
Ferrules (the diameter of the ferrule depends on the diameter of the power wiring and the
construction)
•
Wiring (use twisted pair communication cable, for a maximum of 49 ft (15 m) between Wall
Connectors)
Note: Tesla recommends that you use a shielded cable to limit potential interference.
•
Level
•
Machine drill
Overview of Installation Steps
Warning: After you run service wiring to the installation site using metal flame retardant
conduit, install the appropriate upstream circuit breaker, TURN OFF AND VERIFY POWER IS
OFF BEFORE CONTINUING.
Then follow these steps to install the Wall Connector:
•
Install the Low Profile Bracket for Rear or Bottom Entry Wiring on page 16
•
Install the Top Entry Bracket for Top Entry Wiring on page 17
•
Prepare for Installation on page 18
•
•
Set the Operating Current on page 21
•
Secure the Cover and Power Up on page 22
Step-by-Step Installation Instructions
Step-by-Step Installation Instructions
15
Содержание 1069742-00-A
Страница 13: ...Top Entry Planning Your Installation 12...
Страница 38: ...t t rF P N 1069742 00 A...