Tescom Nobby NTE10, Руководство пользователя, Страница: 9 / 32

1
Remove cap.
2
Push down on the Cool Switch for a while.
●
If the Cool Head feels too cold, use it in an area with a high ambient
temperature.
3
Begin using once the Cool Facial Care power light
becomes steady. Check the Cool Head with your
fingertip.
●
If the Air Intake or Exhaust are blocked, the Head will not cool properly.
4
Hold so as to not block the Air Intake or Exhaust.
●
For use on the same area, apply the head for 1 second and remove
it for 1 second, repeatedly.
●
The power will automatically shut off 5 minutes after pushing the
Cool Switch.
5
Gently apply the Head mainly to the area where
you have issues with your pores (nose, cheeks,
etc.) and slowly move it while patting.
When that happens, a beeping noise will alert you.
6
After 5 minutes the power will automatically
shut off.
After turning off the power, the temperature of the Cool
Head and main unit will temporarily increase, but this is not
a malfunction.
The main unit will warm up while in use, but this is not a malfunction.
The noise while using it is the cooler. It is not a malfunction.
Step 2 Cool Facial Care
Cool Head
●
Push the Cool Switch again and the Cool Facial Care power light
will turn off and cooling operation will end.
How to Use How to Use
W a r n i n g
● Do not leave in direct sunlight (inside a car in summer, etc.) or near heating devices.
This can cause deformation or discoloration.
When you want to stop partway through
1
Connect the power adapter to the main unit and power
outlet.
2
Being LED Care or Cool Facial Care.
Follow directions (Pages 6-7) for use.
3
After use, remove the power adapter from the outlet and
main unit.
To continue charging,
follow the directions on How to Charge (Page 4).
【When to Charge】
●
The signal for low batteries is when the Battery Light begins blinking
while the power is on and a warning beeping occurs for 10 seconds
before the power automatically turns off.
→Charge immediately.
To continue using, use it while plugged in.
【When Using Overseas】
●
This product can be used with AC100-240V power.
【When Using while Plugged In】
Battery Light
Air Exhaust
Air Intake
Alert
Do not use near eyes or ears.
(There is a risk of accident or poor health)
Do not use when skin is injured or cut.
(There is a risk of skin problems or pain)
Warning
●
The Cool Facial Care power light will start to blink.
●
Wait until the cooling preparation ends and the Cool Facial
Care power light becomes steady. (Preparation takes approx-
imately 60 seconds)
Use for 5 minutes or less (including cooling preparation time).
Perform maintenance (Page 9) before storing.
１. Put the cap on the head.
２. Make sure to charge the product.
３. Store it in an area with limited moisture or dust.
How to Store
Long-term
Use for 1 second or less in the same area.
(There is a risk of skin problems or pain)
7 8