Quickstart document
24
Allows you to manually enter the size of the standard used in order to
calculate the angle of a workpiece. This value is stored in the memory as
long as the instrument is not turned off.
6.5 Actions regarding
Min, max,
Δ mode
Definition
Reference
Allows you to take the reference into account in your measurement results
or not.
6.6 Actions regarding
2D mode
Definition
Angle between two lines
Allows to calculate the angle between two selected lines.
Angle by three points
Allows to calculate the angle that make three elements represented either
by simple points or circles. A combination of these two elements types is
also possible.
Circle by three points
Allows to calculate the perfect circle going through three points, circles or
a combination of these two elements’ types.
Bestfit circle
Allows
to calculate the best circle from more than three points or circles’
centres.
Line by two points
Allows to calculate the perfect line going through two points, circles or a
combination of these two elements’ types.
Bestfit line
Allows to calculate the best line from three
or more points or circles’
centres.
Distance
Allows to calculate the distance between two points or circles centres.
Perpendicular distance
Allows to calculate the perpendicular distance between a point/circle and a
line.
Analyse and display results
Allows to display measured and calculated data.
Save result
Allows to save a result in the main programme to be run later.
Y axis as reference
Allows to set a line as Y axis datum.
Z axis as reference
Allows to set a line as Z axis datum.
Origin
Allows to define a point or a circle centre as origin.
Rotate for Y coordinate
Allows to rotate the part to measure Y coordinates.
Rotate for Z coordinate
Allows to rotate the part to measure Z coordinates.
6.7 Actions regarding
Calculator mode
Definition
Change memory
Allows you to change from memory ST1 to measurement memory ST2 (or
vice versa).
Get function
Allows to recall the customised function from a block.
Customised function
Allows you to create a customised calculation block with the previous
result blocks.
