EDOC00082
–
RFID Mobile Case User Manual, rev 1
8
Proper Handling
Take care to not drop the case from excessive height. Do not force the lid to
close and latch; it should close freely. The products inside should not be taller
than the case allows.
Operating Instructions
Setup
Battery installation/replacement
The case is initially shipped without the system battery installed. Once installed
the battery may remain installed until a recharge is required.
Note:
The battery should be fully charged prior to initial use.
Open the battery cover by sliding the latch to the right. Place the connector
end of the battery into the compartment with the label face-up. Then press the
other end down to seat the battery. Finally press the cover closed until it
latches.
When a recharge is needed the external charger may be plugged in at any
time. Allow up to 4 hours for a full charge. The case will remain fully
operational during recharge.
Note:
the case may also be used
without
a battery if the charger is
continuously connected.
Optionally the battery may be removed and recharged external to the case. In
this case a small internal battery will keep critical circuitry powered until a
charged battery is installed. An optional desktop charger is required for
external charging.
Basic User Process
To access the case inventory, first open the four push-pull latches and lift open
the lid. Any desired products may be added or removed as needed. The case lid
should be closed and re-latched when finished. The system will automatically
turn on and begin an inventory process.
The updated inventory data will then be transmitted for processing. Typically,
the inventory process will take about 2 minutes to complete. The case should
remain closed while the inventory process is occurring but can be accessed if
needed. The case will enter battery saving mode after a brief period of
inactivity.
