Email: [email protected] www.terratekintl.com
ACL Group (Intl) Ltd
18
Stand
(Fig. B)
1. Place the bandsaw (A) on its back as shown in Fig. B.
2. Assemble four legs (B) to the inside of the base of the bandsaw, securing each leg with two
ea. carriage bolts (C), flat washers (D) and hex nuts (E). Hand tighten only at this time.
3. Attach a long plate (F) to the rear legs as shown in Fig. B. Secure with 2 ea. carriage bolts
(G), flat washers (H), and hex nuts (I). Hand-tighten only at this time.
4. Repeat above for long plate to the front legs in the same manner described above,
hand-tightening only.
5. Attach two short plates (J) to the right legs and left legs in the same manner. Secure each
leg with 2 ea carriage bolts (K), flat washers (L), and hex nuts (M). Hand-tighten only at this
time.
6. Slip rubber feet onto the ends of the stand legs.
7. Place the saw and stand upright on a level surface. Make sure that all four legs are flat on,
the surface.
8. Tighten all nuts securely.
Table
1) Place table onto the trunnion (Fig. 1) by allowing the saw blade to pass through the slot on
the table.
2) Line up four threaded mounting holes underneath the table (D) with the four mounting
through-holes on the trunnion.
3) Install to the trunnion with four hex screws (M6x16) and lock washers and tighten.
Fig.B
