Email: [email protected] www.terratekintl.com
ACL Group (Intl) Ltd
16
V…………………………volts
A…………………………amperes
Hz……………………….hertz
~…………………….….alternating current
…/m……………….....revolutions per minute
.....................class II construction (double insulated)
Kg………………………..kilograms
n
0
………………………..No load speed
……………….….....Conforms to European Harmonised New Approach Directives
DC ………………..…….Direct Current
IMPORTANT:
Some of the following symbols may be used on your tool.
Symbols
1. DO NOT OPERATE WITH DULL OR WORN BLADES. Dull blades require more effort to use and
are difficult to control. Inspect blades before each use.
2. NEVER POSITION HANDS OR FINGERS IN LINE WITH THE CUT.
Serious personal injury could occur.
3. DO NOT OPERATE THIS BANDSAW WITHOUT WHEEL, PULLEY, AND BLADE GUARDS IN PLACE.
4. WHEN REPLACING BLADES, make sure teeth face down, towards the table. The force of the
cut is always down. Make sure the blade is properly tensioned.
5. CUTS SHOULD ALWAYS BE FULLY SUPPORTED by the table or some type of support fixture.
Always support round stock in a V-block.
6. DO NOT BACK WORKPIECE AWAY from the blade while the saw is running. Plan your cuts so
you always cut out of the wood. if you need to back the work out, turn the bandsaw off and
wait for the blade to come to a complete stop. Do not twist or put excessive stress on the
blade while backing work away.
7. ALWAYS FEED STOCK EVENLY AND SMOOTHLY. Let the blade cut at its own pace. Do not
force or twist blade while cutting, especially when sawing small radii.
8. THIS MACHINE IS NOT DESIGNED TO CUT METAL or other materials, only wood.
Special safety instructions
Only use qualified repair agents to service this power tool.
Only use qualified electrician to repair any damaged wiring.
NEVER remove the grounding prong from the power tool or extension cord.
