5
RF channel is the channel used for Wi-Fi radio in “Access point“ mode.
WEP keys are a sequence of hexadecimal values taken from the numbers 0-9 and the letters A-F. The required length of a WEP key is 10 symbols.
IP address is the address to which will be possible to connect to the programmer.
Default port of the embedded HTTP server of programmer is 80. This port can be changed.
Wi-Fi settings in the “Client” mode shown in Figure 6.
Description of the “IP parameters” table lines in “Client“ mode.
SSID of Wi-Fi router to which connects the programmer.
Wi-Fi password of Wi-Fi router to which connects the programmer.
When DHCP is enabled - all IP parameters will be obtained from the Wi-Fi router. You must know
router assigned IP address to control the programmer.
When DHCP is disabled - you must enter all IP parameters manually.
Default port of the embedded HTTP server of programmer is 80. This port can be changed.
Figure 6. IP parameters in “Client” mode
The programmer scans all available Access Points at startup. Scanning results are displayed in the List of available Access Points table (Figure 7).
This information helps to select a correct RF channel of programmer in the “Access Point” mode. To avoid inter-channel interference of WiFi signals
it is recommended to select the RF channel at the minimum distance of four channels from the strongest neighboring Access Points RF channels.
Figure 7. List of available Access Points table
6.5
Status window
The status window is accessed after selection of “Status” line in the main menu. In this window (Figure 8) status of the programmer and connected
multiswitch is shown.
Figure 8. Status window
In the “Device information” table programmer status information is shown. In the “DC parameters” table DC voltages at “F” connectors of
programmer and current consumption of multiswitch are shown. In the “SAT A DSCR device information” table connected multiswitch status
information is shown.
In the “SAT A total input power” table total input power from LNB outputs, connected to the multiswitch is shown.
When more that one outputs of multiswitches are chained, corresponding SAT B, SAT C ... information and input power tables are displayed.
6.6
Set default parameters command
All parameters of programmer will be restored back to factory defaults. The exception – IP parameters – these parameters will be unchanged.