Installation and Operating Guide
Cleanroom Pass-Through Chambers
©
Copyright 2020 Terra Universal Inc. All rights reserved. • Revised Jul. 2020 • Document No. 1800-07
Terra Universal, Inc. • TerraUniversal.com • 800 S. Raymond Ave. • Fullerton, CA 92831 • TEL: (714) 578-6000 • FAX: (714) 578-6020
7
2.3
Installation for CleanMount® Brackets
Installation Video:
To view a video demonstrating a similar
installation, please visit the following link:
1.
Prepare the wall cut-out as outlined in
Section 2.1
.
2.
See
Section 3.0
if your pass-through chamber includes an
exhaust flange or filter housing for ventilation.
3.
Standing on the “clean” side of the wall, slide the pass-through
completely into the wall until the attached mounting bracket is
flush with the “clean”-side wall surface (See
Figure 5
).
4.
Optional support brackets are recommended if the chamber
protrudes from the wall by 24" (See
Figure 5
) or more.
5.
Check alignment of the pass-through chamber doors by
following the procedures outlined in
Section 2.6 Door
Alignment
.
6.
The “dirty”-side mounting bracket is shipped preassembled. Pop
off the bracket covers and slide the bracket onto the body of the
pass-through (See
Figure 6)
. If necessary, detach one section of
the mounting bracket by removing the two screws at each corner,
creating a “C” shape. Slide the “C”-shaped bracket onto the
chamber and then reattach the missing section, tightening all
corner screws once the bracket is in place.
7.
Confirm chamber positioning with a level, and insert the provided
lag bolts into the pre-drilled holes in the mounting bracket. Thread
the lag bolt into the guide that extends from the “clean”-side
mounting bracket (See
Figure 7
). The size of the pass-through will
determine the number of bolts required. Use a socket wrench to
tighten the lag bolts into the pre-welded nuts until the mounting
bracket is flush against the wall (See
Figure 8
). Be careful not to
over-tighten the “dirty”-side mounting bracket lag bolts. The bracket
should be secured against the wall but should not bend inward
(forming gaps).
8.
Install the bracket covers by snapping each of them into the
bracket clips (See
Figure 8
)
Figure 6:
Slide the “dirty”-side mounting bracket onto
the body of the pass-through
Figure 5:
Diagram of installed
CleanMount® Pass-through
