WARNING:
In order to avoid a hazard for very young children, this appliance should be
installed so that the lowest heated rail is at least 550mm above the floor.
Fix the 4 supports on the wall with the expansion screw. Please note that the fixed supports
can be moved to adjusted the position in order to fix the glass panel.
Procedure 2:
Firstly remove the protective film at the back of the glass, then install the glass panel into
the fixed suport on the wall. Please note that you can adjust the position of the fixed sup
-
port on the wall ti install the glass panel. Then tight the screws on the side of each suport
(a total of four).
Operation instruction
• Place the heater on flat stable surface
• Plug into any 220-240V, 50 Hz, AC source, then turn on the switch at side, you will hear the
sound of „Di”.
• Turn on the heater by press th e power „ ”. The LED will display room temperaturę.
Then please use touch contro lor remote control to set power, temperaturę and time.
• If the appliance is not used for a long time- switch if off with power switch and plug the
item out.
• Attention! Do not cover the product! Convector should not be place under shower or in
swimming pool.
