TermaCook Integral 800, Инструкции по монтажу и использованию

Страница: 30 / 48

GB
30
Terma Cook
Cooking zone diameter Recommended pan base
minimum diameter
190 x 210 mm 120 mm
Power setting Operation time limit
in hours
1, 2
3, 4
5
6, 7, 8, 9
6
5
4
1,5
Operation
The hob
The hob is equipped with an induction cooking mode. An
induction coil underneath the glass ceramic hob generates an
electromagnetic alternating field which penetrates the glass
ceramic and induces the heat-generating current in the pot
base.
With an induction cooking zone the heat is no longer transferred
from a heating element through the cooking pot into the food
being cooked; instead the necessary heat is generated directly
in the container by means of induction currents.
Advantages of the induction hob
· Energy-saving cooking through the direct transfer of energy
to the pot (suitable pots/pans made of magnetisable ma-
terial are required).
· Increased safety as the energy is only transferred when a
pot is placed on the hob.
· Highly effective energy transfer between an induction cook-
ing zone and the base of a pot.
· Rapid heat-up.
· The risk of burns is low as the cooking area is only heated
through the pan base; food which boils over does not stick
to the surface.
· Rapid, sensitive control of the energy supply.
Pan recognition
If a cooking zone is switched on and there is no pan on the zone
or if the pan is too small, there will be no transmission of power.
The symbol in the power setting display points this out.
If a suitable pot or pan is placed on the cooking zone, the power
setting will switch on and the power setting display will light up.
The power supply will be cut off when the pan is removed and the
power setting display will indicate .
If the pots and pans placed on the cooking zone are of smaller
dimension, and the pan recognition still switches on, less power
will be supplied.
Pan recognition limits
The base of pots and pans must be of a certain diameter; if it is
not, the induction heat will not be switched on.
Always place pots and pans in the middle of a cooking zone in
order to achieve the best efficiency.
Important
The minimum diameter required to activate the pan recognition
device may vary according to the type of pot or pan used!
Operation time limit
The induction hob has an automatic time limit function.
The duration of continuous use of each cooking zone depends
on the cooking level selected (see chart).
This requires that the setting of a respective cooking zone is not
adjusted during use.
If the operation time limit has been activated, the cooking zone
will switch off, a short signal will sound and an H will appear in
the display.
The automatic switch-off function overrules the operation time
limit, i.e. the cooking zone is only switched off when the period of
time of the automatic switch-off device has expired (e.g.
automatic switch-off after 99 minutes and cooking level 9 is
possible).
Other functions
If two or more sensor keys are pressed at the same time (e.g.
when a pan is mistakenly put onto a sensor key) no function will
be activated.
An acoustic signal sounds and ER03 will appear. After a few
seconds the appliance will switch off. Please remove the item
located in front of the sensor keys.
Protection against overheating (induction)
If the hob is used at full power for a longer period, it will not be
possible to cool down the electronics system as required at a
high room temperature.
In order to ensure that no excessive temperatures occur in the
electronics system the power of the cooking zones may be
reduced automatically.
Should E2 or ER21 be displayed frequently during normal use of
the hob and at normal room temperature, it is likely that cooling is
not sufficient.
The reason may be that there are no openings for cooling
purposes in the kitchen units. It may be necessary to check the
installation of the hob (see the section on Ventilation).