Terex TL160, Руководство по эксплуатации

Страница: 103 / 114

Care and Maintenance 7
103/112 TL160 Operating Manual 12.9.08 Version 1.0
7.9 Immobilization
7.9.1 Preservation (temporary immobilization ) 7.9.2 During immobilization
When the machine is out of use for 6 months, after
this time all assemblies must be brought to operating
temperature and maneuvered for
approx. 15 minutes.
• Beforehand, the anti-corrosion coat must be
removed from the piston rods, and the openings
of the air filter system and the exhaust pipe freed.
• After the maneuvering cycle, preserve the
machine once more as previously described.
7.9.3 After immobilization
Before putting the machine into operation once
more, the following measures must be carried out:
• Anti-corrosion coat must be cleaned from the
piston rods.
• Seal off the air intake opening of the air filter and
the exhaust pipe opening.
• Remove the air filter insert, check its condition
and replace if necessary.
• Clean the machine with a neutral detergent.
• Check and, where required, re-charge and re-
install the battery.
• Carry out all measures for putting the diesel
engine back into operation listed in the Engine
Operating Manual.
• If the machine has been out of use for more than
6 months, the oil in the assemblies such as axles,
transmission(s), etc. must be changed.
• If hydraulic oil filters such as suction and return
filters as well as breathers have been out of use
for more than 6 months, they must be replaced.
• Lubricate the machine according to the
lubrication plan.
Machine damage
due to damage from storage (e.g. corrosion
damage) during shutdown periods over three
months.
• Perform the preservation measures.
Preservation measures:
• We recommend keeping the machine in a dry,
dust-free room during the storage period.
• Thoroughly clean the inside and outside of the
machine, including the engine.
• Lubricate the machine according to the lubrication
plan.
• Check the oil levels of all assemblies such as
axles, transmission(s), etc. and top up if
necessary.
• Check the hydraulic oil level and top up if
necessary.
• Repair any paint damage.
• Fill the diesel tank completely, to prevent
corrosion of the tank walls.
• Check the antifreeze level in the coolant and
adjust if necessary.
• Perform all preservation measures specified in
the Diesel Engine Operating Instructions.
• Check the tire pressure according to the
prescribed value and protect the tires from direct
sunlight.
• Treat bare piston rods with a commercially
available anti-corrosion agent.
• Remove and clean the battery and keep it
according to regulations in a dry - in winter, frost-
proof - room. Coat connections with a little pole
grease.
• Seal off the air intake opening of the air filter
system and the exhaust pipe opening.