RMX SERIES
1-23
R M X S e r i e s
T e r e x S o u t h D a k o t a
4 8 3 0 1 8 - 3 / 1 5
OPERA
T
ION GUIDELINES
DETERMINING LIFT CAPACITIES
The Aerial Device is equipped with an upper boom angle indicator and load chart on the side of the upper
boom near the platform.
The load capacity must be assured for the entire range of the boom motion throughout a lift. Must insure
capacity is not exceeded at any point during load movement.
After placing booms and jib in position for lifting the load. Refer to the load chart and find the number below
the pointer in line with the load radius. The load radius is defined on the jib capacity chart. The capacity
given here is the capacity of the machine for the unit's position.
NOTE: Load charts shown are for an example only. Each Aerial Device has its custom made load
chart which may have different capacities than shown here.
NOTE: The capacities given on the unit load chart are based on unit setup with the turntable or
truck bed being level.
Use only synthetic rope for winch line. Do not use wire rope.
Do not allow winch line to come in contact with guyline, pole, crossarm, ground, or any
object that can create a path to ground or energize the winch line.
Dirt, grease, other foreign matter, moisture and humidity will all contaminate the winch
line - keep it clean.
Death or serious injury will result if winch line becomes energized.
Inspect rope daily before use.
Use only hooks with a safety latch.
