Terex Genie Lift Guard GS-4047, Дополнение к руководству оператора

Страница: 13 / 20

First Edition • Second Printing Operator's Manual Supplement
Installation Instructions
Part No. 1288739GT Lift Guard
™
Contact Alarm 13
19 Connect the cable to the ESTOP splice
harness.
20 Route the cable through the link stack to the
platform with the existing cables. Secure the
cable using cable ties.
Note: Only route and secure the cable as far up as
the top link. Route the cable so it hangs on the
outside of the link stack.
Genie part number 6578GT.
21 Raise the platform and rotate the safety arm to
the stowed position.
22 Fully lower the platform to the stowed position.
Note: Do not allow the cable to get damaged while
lowering the platform.
23 On the ground control side of the machine,
clamp the cable guide forming to the bottom
edge of the platform.
Note: Refer to the illustrations on page 15 for
installing the cable guide forming's.
Genie part numbers 1290504GT or
1290507GT or 1291462GT.
24 Using a center punch, mark the location to be
drilled at the non-steer end of the machine.
Drill a 17/64 inch / 6,7 mm hole in the side of
the platform. Deburr the hole.
25 Secure the cable guide to the platform using
the provided retaining fasteners. Do not tighten
at this time.
Genie part numbers 824078GT, 824027GT.
26 Mark and drill the location for the cable guide
at the steer end of the machine.
27 Secure the cable guide to the platform using
the provided retaining fasteners. Do not tighten
at this time.
Note: GS-46 and GS-47 models, repeat the drilling
procedure for the center hole of the cable guide.
Do not install the retaining fasteners at this time.
28 Repeat the drilling procedure for the battery
side of the machine.
Genie part numbers 1290505GT or
1290506GT or 1291461GT.
29 Remove the retaining fasteners securing both
cable guides at the non-steer end of the
machine and set aside. Let the cable guides
hang down.
30 Route the 6 pin and the two 2 pin connectors of
the contact alarm harness down through the
slot in the platform that the platform controls
harness is routed through.
31 Secure the coil cord to the hole located under
the AC power outlet using a cable tie.
Genie part number 6578GT.
32 Route the longer part of the harness assembly
to the battery side of the machine.
33 Route the harness under the platform towards
the non-steer of the machine. Secure the
harness to the cable guide using button cable
ties. Do not tighten the cable ties at this.
Genie part number 56361GT.
1 inch
2,5 cm
0.5 inch
1,3 cm