Terex Genie GTH4018 SR, Руководство оператора, Страница: 31 / 121

April 2019 First Edition - Fourth Printing
Part No. 57.0009.0729 GTH-4014 AU, GTH-4018 AU 29
Inspections
Function Tests
1 Select a test area that is firm, level and free of
obstruction. Be sure there is no load on the forks
or attachment.
2 Enter the cab and sit on the seat.
3 Adjust the seat and steering column, if needed.
4 Fasten and secure the seat belt around your waist.
5 Adjust the cab mounted mirror, the rear fish-
eye mirror and the exterior right hand mirrors,
if required.
6 Be sure the parking brake is on and the
transmission control lever is in the neutral
position.
7 Start the engine. See Starting the Engine in the
Operating Instructions section.
Test the Boom Function Joystick
8 Using the control handle, momentarily raise the
boom and extend the boom, tilt the forks up
and down.

Result: All functions should operate smoothly.
9 Using the roller switch, momentarily extend and
retract the boom.

Result: All functions should operate smoothly.
Test the Hydraulic Quick Coupling Lock/
Unlock (if equipped)
10 While pressing the dedicated switch, push and
hold the white thumb button and use the control
handle, momentarily lock/unlock the hydraulic
quick coupling.

Result: All functions should operate smoothly.
Test the Steering
11 Rotate the steer selector to the left side to select
four-wheel steer.
12 Check the steering operation by turning the
steering wheel approximately ¼ turn in each
direction.
 Result: The front wheels should turn in the same
direction as the steering wheel. The rear wheels
should turn in the opposite direction.
13 Straighten the wheels.
14 Rotate the steer selector to the middle position
to select two-wheel steer.
15 Check the steering operation by turning the
steering wheel approximately ¼ turn in each
direction.