Terex Genie GTH4018 SR, Руководство оператора, Страница: 20 / 121

April 2019
18 GTH-4014 AU, GTH-4018 AU Part No. 57.0009.0729
First Edition - Fourth Printing
Safety Precautions
Control Indicators and
Interlocks
Several control indicators and interlocks have been
fitted to the machine. They must never be tampered
with or removed.
Always perform a function test to check the proper
operation of these devices.
Never operate a machine that is malfunctioning. If
the machine starts to malfunction, immediately stop
using it and have it repaired.
Load Management system (LMS)
The Load Management System has been developed
to help the operator to maintain longitudinal stability
of the machine. Audible and visual messages are
provided when the limits of longitudinal stability are
being approached.
However this device cannot replace the experience
of the operator. It is up to the user to adopt the
necessary safety measures to work within the rated
limits of the machine.
The LMS is designed to function only:
• when the truck is static;
• when the truck is on consolidated, stable and
level ground;
• when the truck is performing loading or placing
functions;
• when the LMS is activated (not overridden).
The LMS will only warn the operator in the event of
inadequate stability in the longitudinal plane in the
forward direction.
The Load Management System is not intended
for warning of the risk of overturning in the case of:
•
a sudden overload;
• travelling with the load in the elevated position;
• travelling on rough terrain or on grounds with
obstacles and holes;
• travelling across a slope or turning on a slope;
• driving in bends too fast or too sharp;
Adjustments affecting the setting of the Load
Management System shall be performed only by
authorised personnel.
Seat Interlock
This micro switch is located inside the seat cushion,
and it prevents any machine transmission movements
if the operator is not correctly seated in the driving seat.
Emergency Stop Push-button
This device may be used to stop the machine during
an emergency situation.
By pressing this button, the engine shuts down while
the Load Management System stays active.
Before restarting the machine, it is necessary to reset
the push-button by rotating it clockwise.
Enabling Function Switch on Joystick
The joystick is equipped with an enabling function
switch. This red finger switch must be held pressed
down until the joystick functions have been completed;
if it is released, the manoeuvre stops.
Sensors on Outriggers
Each outrigger is equipped with two sensors:
• Proximity switch: it tells when the outrigger is
less than 10 cm from the ground, cutting out the
transmission;
• Magnetic codified sensor with target: it tells when
the outrigger is fully lowered;
The Load Management System changes configuration
from "OFF OUTRIGGERS” to “ON OUTRIGGERS”.
The outrigger indicator light on the dashboard also
switches on