- - XM767-V1.2-NR
１０
You can set the same starting address for all fixtures or a group of fixtures, or make different
address for each fixture individually.
If you set the same address, all the units will start to “listen” to the same control signal from the
same channel number. In other words, changing the settings of one channel will affect all the
fixtures simultaneously.
If you set a different address, each unit will start to “listen” to the channel number you have set,
based on the quantity of control channels of the unit. That means changing the settings of one
channel will affect only the selected fixture.
In the case of the move head, which is a 14 channel fixture, you should set the starting address of
the first unit to 1, the second unit to 15 (14 + 1), the third to 29 (14 + 15), and so on.
Note:
The modes of DMX 512 data are shown via the display:
DMX OK
NO DMX
1. After switching on, the device will automatically detect whether DMX 512 data is received or
not. If the data is received, the display will show
"A.001"
with the actually set address. If there is
no data received at the DMX-input, the display will flash
"A001"
with the actually set address.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of
the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal
wires are swap in the input connector.
It’s necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in
order to ensure proper transmission on the DMX data link.
8. Control Board
There are four keys on the control panel , which could be used to set the address, turn ON/OFF,
operating the program and reset.
[Mode/Esc]
press this key to enter into edit mode. Press this key under the edit mode if you want
to return to previous menu. it will exit from edit mode 60 seconds after the last keypress
[UP]
screen will flash when pressing this key in normal mode, the adress value will increasing.
Keep pressing this key, the address value will increase rapidly. it will exit from flash 60 seconds
after the last keypress. Press this key under edit mode, you can choose the function you want
from the buttom up in the menu.
[DOWN]
screen will flash when pressing this key in normal mode, the adress value
will idecreasing. Keep pressing this key, the address value will decrease rapidly. it will exit from
flash 60 seconds after the last keypress. Press this key under edit mode, you can choose the
function you want from the top down in the menu.
[ENTER]
this key is functionless when in normal mode. Press this key under the edit mode, it
will enter into next menu.
