Terbly GLW760 IP, Руководство пользователя

Страница: 16 / 36

GLW760 IP User Manual XM1586-V1.1-NR 15
8. DEVICE DMX START ADDRESS SELECTION
All fixtures should be given a DMX starting address when using a DMX signal
，
so that the
correct fixture responds to the correct control signals
.
This digital starting address is the channel
number from which the fixture starts to
“
listen
”
to the digital control information sent out from the
DMX controller
.
The allocation of this starting address is achieved by setting the correct address
number on the display located on the base of the device
.
You can set the same starting address for all fixtures or a group of fixtures
，
or set different
addresses for each fixture individually
.
If you set the same address on all devices
，
all the devices will start to
“
listen
”
to the same control
signal from the same channel number
.
In other words
，
changing the settings of one channel will
affect all the fixtures simultaneously
.
If you set a different address
，
each unit will start to
“
listen
”
to the channel number you have set
，
based on the quantity of control channels of the unit
.
That means changing the settings of one
channel will affect only the selected device
.
In the case of the LED moving head
，
which is a 26 channel fixture
，
you should set the starting
address of the first unit to 1
，
the second unit to 27(26 + 1)
，
the third unit to 53 (26+ 27)
，
and so
on.
9. DISPLAY
The Display offers several features
：
you can set the starting address
，
run the pre-programmed
program or reset the device
.
The main menu is accessed by pressing the -button until the display starts flashing
.
Browse
through the menu by pressing the -button
，
-button
，
-button or -button.
Press the Enter-button in order to select the desired menu
.
You can change the selection by
pressing the -button
，
-button
，
-button or -button. Confirm every selection
by pressing the -button
.
You can leave every mode by pressing the -button
.
After
accessing the edit mode
，
the unit will automatically exit to the main menu after 15 seconds from
the last button press
.
When the unit is powered on
，
if no data signal is connected after 1 minute
，
then the display will switch off automatically
.
The Display does not need external power to
operate
.
Hold down the -button for 3 seconds and the Display will turn on by using the
unit’s battery built in battery
.