Terberg YT182, Руководство по эксплуатации

Страница: 60 / 71

TD2303-08EN YTxx2 59
WARNING
Make sure that all staff is kept well clear of the cab during the lowering procedure.
The electrical pushbutton for cab lowering must be accessed via the chassis to eliminate the
danger of injury.
7.2.4 Maintenance of cab tilting system
Cab tilt pump
Check the oil level at every lubrication service. Always check the oil level with the cab down.
It should be possible to see the oil level in the filling hole. When the oil level is too low, top it
up with the same type of hydraulic oil as already used in the system.
Bleeding the tilt system
Move the hydraulic valve to the open position (down position).
Remove the combined filler/level plug and pump the lever, which will automatically bleed the
air from the hydraulic system.
Refit the combined filler/level plug.
7.3 Starting and stopping the engine from under the cab (optional)
A start/stop box can be fitted under the vehicle cab as an optional extra.
It can be used to start or stop the engine when the cab is in the tilted position.
Procedure:

Ensure the transmission is in neutral.

Ensure the parking brake is applied.

Leave the ignition on.

The engine can be started using the START button.

The engine can be stopped using the STOP button.
7.4 Electrical equipment
Set the main switch to the OFF position when you do any maintenance on the electrical
system of the vehicle. If you remove the batteries, make sure to disconnect the negative
terminal first.
7.4.1 Main switch
The main switch is located near the batteries. You can use it to
connect or disconnect the power supply.
When the tractor is not in operation, do set the main switch to the
OFF position.
The engine will only start when the main switch is set to the ON
position. Do not set the main switch to the OFF position when the engine is running!
CAUTION
If you set the main switch to the OFF position, the electrical system will still contain energy
for approximately 5 minutes!
Wait 5 minutes to make sure that the equipment is de-energized completely before you do
any maintenance on the electrical system of the tractor!
START
STOP