Demonstration
16
1-13
Connecting THDB-HTG Board to Altera DE3 Board
This section describes how to use the THDB-HTG board with Altera DE3 Board.
Figure 4.2 illustrates how the THDB-HTG board is connected to the Altera DE3 board. Users need to pay extra
attention to the following three points:
1.
THDB-HTG board can be connected to any of the HSTC connectors J1, J3, J5, and J7 on the DE3
board.
2.
The JTAG Switch on the THDB-HTG board MUST be switched to “Bypass” position, or the FPGA device
on DE3 board will not be detected.
3.
Users can use DE3_System_builder to create Quartus II project. Please refer to Figure 3.2 for the
corresponding signal names.
Figure 4.2 Connecting the THDB-HTG board to the Cyclone III starter board
