Terasic Stratix 10 DE10-Pro SX, Руководство пользователя

Страница: 10 / 16

DE10-Pro SX
Linux Botting Started
Guide
June 28, 2019
www.terasic.com.tw
10
1.7 Setting Up UART Terminal
This section presents how to install the drivers for the USB to UART chip on the DE10-Pro SX
board and how to set up the UART terminal on your host PC. The DE10-Pro SX board
communicates with the PC through the Mini USB connector. You should install the USB to UART
driver and configure the UART terminal before you run Linux on the board.
Figure 1-9 Hardware Setup for UART Terminal

Installing the Driver
1. Connect your computer to the development board by plugging the USB cable into the
mini USB connector of DE10-Pro SX. (Connection setup is shown in
Figure 1-9
)
2. Power on the board and open the computer device manager in Windows. You will find
an unrecognized FT232R USB UART (See
Figure 1-10
).