3-3
Note
Securely fix the pump in place with the bolts. Otherwise, it may lead to
abnormal vibration or other problems.
(13) To lift the pump, pass a rope or the like through the
eyebolt
※
of the motor.
・
Size of eyebolt
：
M8
※
The eyebolt is not included.
(14) To install the pump to equipment, lift it up with a
rope through the eye bolt.
(15) Carry out touch-up painting on the threaded
part for eyebolt when removing the eyebolt
after installation.
Paint may come off and rust may occur.
Caution
When installing the pump, do not put your hands between the pump flange
and the pump mounting surface. Otherwise, it may lead to an injury.
(16) Do not hoist the equipment with the pump attached. Otherwise, it may damage the hoisting
equipment/devices and the pump may fall.
(17) When you hoist or move the pump, be sure to handle the pump carefully so that the pump section
would not be subjected to an impact or imbalanced load. The container may greatly tilt depending
on its center of gravity.
Warning
Before hoisting the pump, refer to the catalog, dimensional outline drawing,
and other documents to check the weight of the units. Do not hoist any
units if its weight exceeds the rated load of the hoisting equipment/devices.
Warning
Never use a pump that is being hoisted or install parts on it. Otherwise, the
pump may fall.
Caution
When hoisting the pump, pay attention to its center of gravity. Otherwise,
the pump may topple over or fall, thus leading to an injury.
Caution
When you lift the product by hand, pay attention to its center of gravity and
weight. Do not allow a single person to lift a product heavier than 15 kg.
Otherwise, it may put strain on the body, thus leading to an injury.
(18) If the pumping liquid is cold, condensation may occur inside the motor while the pump is stopped.
Take measures to prevent condensation, for example, by installing the pump in a sufficiently dry
room or by heating and insulating the motor even when the pump is stopped.
(19) Carry out touchup painting at a time interval suitable for the environment of use. Depending on the
humidity, condensation, and other conditions, rust may form on areas such as threaded parts,
worked areas, anticorrosive-coated sections.
Eyebolt
2xM8
Mounting
hole
