Teradek Bolt LT 1000 RX, Быстрый старт

Страница: 4 / 9

2
Move the power switches on both the transmitter and receiver (J) to the ON position. Video appears
within a few seconds.
Connect the output from your video source to the SDI input (G) on the Bolt transmitter. Connect the
SDI or HDMI output (F) from the Bolt receiver to the video input on your monitor.
1
2
POWER AND CONNECT
3
Power the Bolt transmitter and receiver with the included A/C adapter, or if Bolt is equipped with a
battery plate accessory, connect a compatible battery (L series or LP-E6).
NOTE: If mounted upright on a stand above the monitor, use a right-angle SDI adapter to
relieve any strain caused by the weight of the cable, and to avoid damaging the SDI output’s
internal connectors.
DEVICE OPERATION
• Keep the transmitter and receiver at close range for 60 seconds after powering on the devices. This
allows them to scan for and select the best wireless channel.
• For best results when using multiple Bolt systems in the same area, place the transmitters and
receivers a few feet apart from each other.
• Operation of other wireless equipment may interfere with the Bolt. Try to separate other wireless
transmitters and receivers as much as possible.