AmiNet110
User Guide V1.0.3
16
7.2
Network Configuration
Ethernet Link:
This option enables users to configure the STB´s network port characteristics.
You can choose between these options:
100MbTX-FD
(100 Mbit/s, Twisted Pair, Full Duplex)
100MbTX-HD
(100 Mbit/s, Twisted Pair, Half Duplex)
10Mb-FD (10 Mbit/s, Full Duplex)
10Mb-HD(10 Mbit/s, Half Duplex)
This option has been added especially to address specialized network and/or
administration requirements.
.!.
In most cases it is sufficient (and recommended) to leave this
setting on AUTO, so the AmiNet110 and the connected switch
can deal out the preferred connection on their own. (AUTO is the
default link mode setting up to firmware version 0.9.4)
DHCP Info:
If there is a DHCP Server in your network you can use dynamic routing. In this case
you do not need the settings IP-address, Netmask, Gateway and DNS. For dynamic
routing check the button.
If you chose DHCP it is easy to find out your IP-address. Select ‘DHCP Info’ (so that it
is highlighted blue like in the picture above) and press ‘Return’ and you get the
Information about your current IP-address, Netmask, Gateway, and DNS Server.
Hostname:
*
The Hostname is to identify your AmiNet110 in a Network. For Example: ‘AmiNet110’
.!.
Empty spaces cannot be entered
IP Address:
*
The IP-address is an identifier for your AmiNet110 in the TCP/IP network. Networks
use the TCP/IP protocol route messages based on the IP-address of the destination.
The format of an IP-address is a 32-bit numeric address written as four numbers
separated by periods. Each number can be zero to 255.
For example, 192.168.90.1
