TEQSAS LAP-TEQ PLUS, Руководство по эксплуатации

Страница: 19 / 36

Operation
LAP-TEQ PLUS 19
5 Operation
5.1 Power on/off
Check the condition of the device:
► Check for visible defects.
► Check to make sure that all parts of the device are firmly mounted.
Warning!
Danger of eye injuries from laser beams!
If the laser beam hits the eyes via optical devices, this can
result in irreparable damage.
► Never look into the laser or direct the laser beam onto
reflecting surfaces!
► Make sure that no one is within the effective range of the laser.
► Power on: Press the “Power” button for about 3 seconds.
If the system has started up correctly, the green laser lights up and the current
angle measurement is displayed.
The angle measurement is refreshed every 2 seconds. This integrated feature
is necessary to prevent the last digit in the display from changing constantly,
which could result for example from wind movement.
Notice
Pressing the “CAL” button on the display unit during operation
does
not switch the sensor unit to calibration mode. Instead, a
short guide to calibration is displayed. The display automatically
switches back to the angle measurement after a few seconds.
► Power off: Press the “Power” button again.