• Unfold canopy top, place over cross
cables and tarp
• DO NOT walk on canopy
• Center the top and stretch to edges
(flap as you go, to create ‘lift’)
Note: Locate the O-ring pull strap
attached to one of the corner loops,
that should be the
last
loop to be
put in place—the strap can be used
to pull the loop in place
• Connect three corners first, to the
corner fittings
• See (
figure B.
)
• The last corner requires the use of
an anchoring stake
• Pull the first three corner loops over
the corresponding outcrop-ring
• For the last loop, place an anchoring
stake through loop and against outcrop
• Pull corner loop and pry at the same
time— (pull stake back, away from tent)
— the overall canopy position should be
straighten, this will help with final loop
• Finally, push loop in place and slide
out anchoring stake
• Use O-ring pull strap to pull the
loop into place
(FIGURE B.)
Last corner loop
(pull back on stake/tool)
Outcrop-ring
Corner loop
Stake Line
STEP 4. CANOPY TOP
Legs
Ground
Stakes
(example, not size specific)
(example, not size specific)
Approx. 5ft.
from frame
5 ft.
5 ft.
• With the canopy on and the frame
in place, measure for ground stake
location
• Lay leg poles around frame to help
guide your measurement
• Measure 5 feet straight out from frame,
at each leg connector
• Slide stakes through D-ring of 1˝ ratchet
strap, before you continue
• Remember, one ground stake per leg
pole at the stake line, see (
figure C,
next page
) for proper staking
STEP 5. POSITIONING STAKES
4
716 832-TENT
(
8368
)
Canopy top
Tarp
