TensCare perfect BEAUTY, Инструкция по эксплуатации

Страница: 18 / 136

17
8.2. PAD ADVICE
•
The electrode pads supplied are
reusable but for single patient use.
•
In order to obtain the best
conductivity through the electrode
pads always ensure that they are in
good condition and tacky.
•
Before use make sure your skin is
clean and dry.
•
Peel the electrode pads from their
protective plastic shield by holding
and lifting one corner of the pad and
pulling.
Do not pull on the pigtail wire
of the pad.
•
After use always replace the
electrode pads on the plastic liner
and replace them in the re-sealable
plastic bag.
•
If the electrode pads dry out, then it
is best to buy a replacement pack. In
an emergency, it may be possible to
restore some of the tackiness of the
pad by adding a tiny drop of water on
each pad and spreading around. If
too much water is added, the
electrode pad will become too soft. If
that happens then it is suggested in
order to try and re-establish some
adhesiveness, to place them sticky
side up in a refrigerator for a few
hours.
•
In very hot weather the gel on the
electrode pads may become soft. In
such cases place them, still on their
plastic liners and in their pouch into
a fridge until they return to their
normal condition.
•
The electrode pads provided are
latex-free.
•
Replace the electrode pads when
they lose their stickiness.
Poor connection may cause
discomfort and skin irritation.
•
Storage life of an unopened pack of
electrode pads is 2 years. This may
be affected by very high
temperatures or very low humidity.