13
Commissioning
Connect the Blue Voice L to your T3 telephone (bonding)
Connecting (bonding)
Your T3 telephone with Blue Link must already be in "Discovery mode".
Blue Voice L is switched off.
Press the right softkey for a long period.
Blue Voice L starts up. The display shows
No device
or changes between
Search
devices
and
No device
.
Press the "Search all" left softkey.
The display first shows
Search for available devices
. The search can last
approximately one minute. The device available or a list of all devices available will
then be displayed.
Select the
Tenovis T3
device if necessary.
Confirm.
"Device details" are displayed:
Press the "Enrolment" right softkey.
...
Enter the PIN from Blue Link and confirm with the "Enrolment" right
softkey.
The message
Registering with Tenovis T3 successful
appears and
Blue Voice L goes into idle state.
i
Note
•
Only those Bluetooth devices with the CTP profile are displayed.
•
If more than one "Tenovis T3" device is shown, compare the Bluetooth device
addresses of the device details. You will find this number in the Blue Link menu of
the T3 telephone under "Address/Name".
It is easier to select the correct telephone when you have entered a meaningful
name on the T3 telephone for the Blue Link. Refer to the operating instructions for
Blue Link if necessary.
•
If the system search was not successful, you can try again using the "Retry" soft-
key. Ensure that the T3 telephone is in Discovery mode.
•
The Blue Link PIN as set in the factory is "0000".
