IB 9006790 (07--2010)
2
INSTALLATION:
1. Remove both existing rear wheel guards from
the right drive support housing. Set the
mounting hardware aside. Discard both wheel
guards Refer to Fig. 1.
Remove and
discard right
rear guard
Set all
hardwareaside
Remove and
discard left
rear guard
Right drive
supporthousing
FIG. 1
2. Remove the 2--hole tube clamp from the
hydraulic tubes attached to the right wheel
drive motor. Set the clamp and mounting
hardware aside. Refer to Fig. 2.
Remove and set
aside 2--hole tube
clamp and hardware
FIG. 2
3. Remove both hydraulic tubes from the right
wheel drive motor. Discard the hydraulic
tubes. Refer to Fig. 3.
4. Disconnect the 46” hydraulic hose from the
t--fitting and the right wheel drive motor.
Discard the hose. Refer to Fig. 3.
5. Connect the 51” hydraulic hose (4) to the
t--fitting. Refer to Fig. 3.
To left
wheel drive
motor
Right wheel
drive motor
Flow divider
valve
Remove and discard
right outer hydraulic
motor tube
Remove and discard
right outer hydraulic
motor tube
Remove and discard
46” hydraulic hose.
Replace with 51”
hydraulic hose (4)
T--fitting
FIG. 3
