IB 9006790 (07--2010)
1
INSTRUCTION BULLETIN
No. 9006790
Machine: S30 X4
Published: 07--2010
Rev. 00
NOTE: DO NOT DISCARD the Parts List from the Instruction Bulletin. Place the
Parts List in the appropriate place in the machine manual for future
reference. Retaining the Parts List will make it easier to reorder
individual parts and will save the cost of ordering an entire kit.
NOTE: Numbers in parenthesis ( ) are reference numbers for parts listed in Bill of Materials.
Installation instructions for
kit number 9006789
SYNOPSIS:
This kit contains the parts needed to replace the rear right side hydraulic tubes on S30 X4 machines.
Please follow step-by-step instructions.
SPECIAL TOOLS / CONSIDERATIONS: NONE
(Estimated time to complete: 2 hours)
When assembling / disassembling hydraulic components:
1. Thoroughly clean outside of hydraulic components
before
disconnecting hydraulic hoses or fittings to
prevent contaminants from entering system.
2. Flush hoses and fittings with air, solvent, or hydraulic fluid and cap disconnected hoses or open ports
to prevent contaminants from entering system.
3. Mark hydraulic hoses with locations of where they are attached. Markings make it easier to reconnect
hoses to proper locations.
4. Discard all hydraulic fluid drained from the system. Use only new approved hydraulic fluid to replenish
hydraulic reservoir. Hydraulic fluid is potentially dangerous to the environment. Obey all federal, state,
and local laws/regulations governing the disposal of environmentally hazardous materials when
disposing hydraulic fluid.
PREPARATION:
1. Park the machine on a clean level surface,
turn off the machine, remove the key, and set
the parking brake.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, set parking
brake, turn off machine, and remove key.
2. Place a chock block in front of the left and
right front tires.
3. Jack up the left rear end of the machine and
position jack stands underneath the machine
for additional support. Refer to the
MAINTENANCE section of the Operators
Manual for additional information.
FOR SAFETY: When servicing machine, block
machine tires before jacking machine up. Use
a hoist or jack that will support the weight of
the machine. Jack machine up at designated
locations only. Support machine with jack
stands.
4. Remove the right rear tire from the machine.
Set the tire and lug nuts aside.
