Tennant S10, Руководство по эксплуатации

Страница: 28 / 48

S10 SERVICE INFORMATION Maintenance & Repair
S10 331585 (6--07) 22
ADJUSTING THE SIDE BRUSH
FOR SAFETY: Before leaving or servicing
machine; stop on level surface, set parking brake
(if equipped), and turn off machine.
1. Pull the side brush arm up into the raised
position.
2. Remove the side brush mounting hardware.
3. Position the side brush on the shaft until there is
approximately 25 mm (1 in) between the floor
and the brush bristles.
4. Align the side brush with the drive shaft holes.
5. Secure the side brush to the drive shaft with the
mounting hardware.
NOTE: It may be necessary to readjust the side brush
drive belt tension after adjusting the side brush height.
DEBRIS HOPPER AND DUST FILTER
DEBRIS HOPPER
The debris hopper should be emptied after every work
shift, or when the hopper is full. The debris hopper
floor clearance should be checked after every 50
hours of operation. The dust filter to hopper seal can
also be adjusted to correct dusting when shaking the
dust filter.
CHECKING AND ADJUSTING THE HOPPER
FLOOR CLEARANCE
FOR SAFETY: Before leaving or servicing
machine; stop on level surface, set parking brake
(if equipped), and turn off machine.
1. Empty the debris hopper and replace it on the
machine.
2. The bottom rear metal edge of the hopper
should clear the floor by 15 mm (0.5 in). Also,
be sure the hopper is level side to side.
3. To adjust the hopper (A), loosen the hanger
bracket bolts (B), reposition the hanger bracket,
and retighten the hanger bracket bolts. Be sure
the hopper brackets do not rub against the pivot
pins preventing the hopper from floating.
B
A
03159
A. Hopper
B. Hanger Bracket Bolts