(6)
Carrier sling
The carrier sling is intended to prevent accidental slipping of the gas-leak detector.
Fasten the carrier loop to the respective fastening eyelets at the end of the detector.
(7)
Cover
The cover portents the sensitive gas sensor from damage. Remove the cover
before operation and replace it when you have finished operating the detector.
(8)
Battery chamber
The battery chamber serves to hold the two micro batteries which are necessary for
operation.
(9)
Battery chamber cover
(10) Static aerial
Inserting the batteries and battery exchange
The device may be operated only with batteries.
Storage batteries are not suitable for operation.
Slide the battery chamber cover (9) off the device.
Insert two micro batteries into the battery chamber (8). The positive pole of the
batteries must point towards the gas sensor(1). Is possible, use alkaline batteries
since they ensure a longer operating time.
Close the battery chamber cover again.
The battery requires changing if the green display LED (3) does not iluminate
after the device has been switched on, or if the device no longer responds
properly.
Note: If the product is switched on in a room without any gas and starts to
make a continuous beeping sound, an inspection of the batteries is necessary
to check whether the batteries have run out or are running low.
To avoid damage caused by leaking batteries, remove the battery if the device is
not to be used for a long period of time.
Remove depleted batteries immediately.
