www.element14.com
www.farnell.com
www.newark.com
www.cpc.co.uk
TM
TM
Page <11>
V1.0
12/04/18
5-14. Displaying Temperature
Ambient temperature is displayed on the secondly show as a reference. The temperature can be displayed in either °C or °F.
Press
“Unit ”
to select unit °C or °F.
5-15. Holding the Displayed Readings
• Press
“Hold/Zero”
to freeze the readings on the display .The display shows HOLD.
• Press
“Hold/Zero”
again to turn off the HOLD function
5-16. Viewing the MIN, MAX, and AVG Readings
• Press
“MAN/MIX”
to step through the maximum (MAX), minimum (MIN), or the average (AVG) readings. The elapsed time
since entering MAX/MIN/AVG mode, or the time at which the minimum or maximum occurred appears on the display.
• Press
“P/V/F”
to show the maximum, minimum, and average of pressure, velocity or flow, and temperature value.
• Press
“MAN/MIX”
button for 2 seconds to exit MAX/MIN/AVG mode.
5-17. Saving Samples
The Meter saves various samples in its three major modes. To save a sample, do the following:
• When taking a sample, press
“Save/Clear’’
to store the sample. The Meter can save up to 99 samples in each of its three
modes.
• If the memory is full (99 samples have been stored), more samples cannot be stored. If the user attempts to store another
sample, the Meter shows “FU” and does not save new readings.
5-18. Recall and Clearing Sample Data
•
The Meter stores data that sometime will need to be recall and periodically to be cleared. Individual samples or the entire
data memory can be cleared. When the memory is full (99 samples), it shows
”FU”
(Full) on the display when
“Save/
Clear’’
is pressed and the Meter emits short beeps and will not save any value unless some samples are cleared.
To recall sample data, do the following:
• Press
“P/V/F”
to recall samples for that mode.
• Press
“Avg/Rec”
(RECALL)and hold the button for 2 second to recall samples. The last measurement saved appears first.
Use
“Unit ”
and
“Unit ”
to locate the desired sample.
• Once the samples are taken, press
“Avg/Rec”
to view the average of all the samples.
• Press
“Avg/Rec”
and hold the button for 2 second to exit recall mode.
To clear individual sample data, do the following:
• Press
“P/V/F”
to recall samples for that mode.
• Press
“Avg/Rec”
(RECALL) and hold the
button for 2 second to recall samples. Use
“Unit ”
and
“Unit ”
to select the desired
sample.
• Press
“Save/Clear’’
to clear the sample.
Note that the number of samples displayed
is reduced.
• Press
“Avg/Rec”
and hold the button for 2
second to exit recall mode. To clear all sample
data, Refer to Step clear memory setting ..
(“Changing Setup Options.”)