2
Please read these instructions carefully before use and retain for future
reference.
This instrument is designed and manufactured in compliance with: G84793,
lEC61010-1, CAT III 600V, Pollution Degree 2 and Double Insulation standards.
•
Check the test leads, probes and case insulation before using. If you find any
breakage or abnormality, or you consider the device is broken, stop using the
device immediately.
•
When using the test probes, keep your fingers behind the finger protection ring.
•
Do not use the meter with the back cover open.
•
Select appropriate test range for measurements.
•
Ensure all inputs are less than the range selected otherwise it may cause electrical
shock or meter damage.
•
Do not change the range selector position during voltage or current
measurements.
•
Do not apply a voltage over 600V between COM terminal and ground.
•
Take caution when working voltages are above 60V DC or 30V AC rms.
•
Do not connect the meter to voltage signals when the range selector is on current,
resistance, diode or continuity range.
•
When measuring current, each single measurement should be shorter than 10
seconds. For current values over 5A, the wait period between each measurement
must be longer than 15 minutes.
•
When a measurement has been completed, disconnect the testing probes from
the circuit under test.
•
Replace the batteries as soon as the low battery indicator appears on the display.
•
Remove dead batteries from the meter or if it is not going to be used for a long
time.
•
Never mix old and new batteries together, or different types of batteries.
•
Never dispose of batteries in a fire, or attempt to recharge ordinary batteries.
•
Before replacing the battery, turn off the meter and disconnect all the test probes.
•
To prolong battery life turn off the meter after use.
•
CAT III: Measurement category III is for measurements performed in the building
installation. Examples are measurements on distribution boards, circuit-breakers,
and wiring, such as cables, bus-bars, junction boxes, switches and socket-outlets
in the fixed installation, and equipment for industrial application and some other
equipment such as stationary motors with permanent connection to the fixed
installation.
•
Only use test leads and probes that are in compliance with IEC 61010-031, and
rated CAT III 600V.
SYMBOL GUIDE
Low battery
Grounding
Warning
Continuity Buzzer
AC
DC
Fuse
Double insulated
Diode
IMPORTANT SAFETY INFORMATION
