Snappi Seat Standalone User Manual
Document No: 053-07 v5
Page 47 of 54
January 2019
Snappi Seat Standalone User Manual.doc
Fig 6.9.2
The foot muff comes supplied with button-
hole slots to allow harnessing to pass
through the cover (see dashed lines, fig
6.9.2, left).
These slots are not cut when supplied as
different patients have different harnessing.
Open out the foot muff by undoing the zips
down each side, then place it down onto a
flat surface as shown.
Identify the slots that you need for your
harnessing:
- The upper two slots are used for 2 and
4-point pelvic belts
- The lower middle slot is used for the
groin strap
Carefully cut open the slot using a sharp
Stanley knife by cutting the material in-
between the two lines of stitching as shown
(see Fig 6.9.3, right). Note- only cut the
amount of material you need for your
harness straps, you do not need to cut the
entire length of the slot.
Important:
take care only to cut the
material in the middle of the slot. Do not cut
any material outside this area. Any damage
caused to the foot muff during cutting will
not be covered by the warranty.
Fig 6.9.3
