Tendercare Ltd
Fold-A-Way Spring - Workshop Manual
Document No 045-02v1Foldaway Spring
workshop manual.doc
Authority. Quality Controller
Authorised. J Adams
Page 8
Sept 05
4.3 Tilt in Space
: - Follow the instructions in section 4.9 of the user manual.
Check that the tilting and seat locking system operates properly throughout its range of
adjustment.
Important – Always support the front of the seat when operating the gas spring release
lever. If the front of the seat is not supported, the seat may move very swiftly
and could cause distress to the operator
4.4 Brakes
: - Follow the instructions in section 4.10 of the user manual.
1.
Test operation of the brake and make sure the brake assembly
is secure and operates properly. When the brakes are
ON
the
rear wheels should be locked. If they do not lock either the
wheel is worn or the brake rod is bent. Either or both these
items should be replaced. See sections 7.1 and 7.4 below.
2.
To put the brakes on press the pedal down and backwards with
the sole of your foot until it locks into place.
3.
To release the brake, place your toe under the lever and lift up.
4.5 Front Wheels – (Castors)
1)
Make sure the castor assembly is secure and operates properly. If the castor assembly is
damaged it must be replaced as a complete unit. See Section 7.2 below.
5. Cleaning
Make sure the pushchair is clean and well presented. If there is any dirt it should be cleaned
off as follows: -
5.1 Frame
1)
To clean the frame, wipe with a damp cloth and dry thoroughly.
2)
For more stubborn stains wipe with a damp cloth and warm water in which a little
mild soap has been dissolved. Dry thoroughly.
3)
Never use furniture polish or any spirit to clean the frame.
5.2 Patterned cover
1)
Remove the cover from the pushchair. Remove the harness and support boards from
the cover. Wash as per the instructions on the cover (40°C Synthetic Wash).
2)
Dry cover thoroughly before re-assembly.
Do not tumble dry
.
ON
OFF
