300M Wireless AP
22
11b/g mixed mode:
Select it if you have 11b and 11g wireless devices in your wireless network. Up to
54Mbps wireless rate is supported in this mode.
11b/g/n mixed mode:
Select it if you have 11b, 11g and 11n wireless devices in your wireless network. In
this mode wireless connection rate is negotiated. Up to 300Mbps wireless rate is supported in this mode.
3. Channel:
Select from 1~13 channels or Auto. It is recommended to select a channel that is the least used
by neighboring networks.
4. Channel Bandwidth:
Select a proper channel bandwidth to enhance wireless performance. This option is
available only in 802.11b/g/n. Wireless speed in the channel bandwidth of 20/40 is 2 times in 20.
5. Extension Channel:
This is used to ensure N speeds for 802.11n devices on the network. This option is
available in 11b/g/n mixed mode with channel bandwidth of 20/40.
6. WMM-Capable:
WMM is QoS for your wireless network. Enabling this option may better stream wireless
multimedia data such as video or audio (recommended).
7. ASPD Capable:
Select to enable/disable the auto power saving mode. By default, this option is disabled.
8. Key Update Interval:
You can configure security key's update cycle (60
—99999 seconds) here. If it’s set
to 0, key will not be updated.
9. Channel Scan:
You can click
Enable Scan
to scan wireless networks.
3.5.3 Advanced
Click
Wireless > Advanced
and here you can configure advanced wireless settings. If you are new to
networking and have never configured these settings before, we recommend you to leave the default settings
unchanged.
1. Beacon Interval:
This is a time interval between any two consecutive Beacon packets sent by an Access
Point to synchronize a wireless network. Specify a valid value between 20 and 999. The default setting is
100.
2. Fragment Threshold:
Specify a valid Fragment Threshold value between 255 and 2346. The default is
2346. Any wireless packet exceeding the preset value will be divided into several fragments before
transmission.
3. RTS Threshold:
Specify a valid value between 1 and 2347. The default is 2347. If a packet exceeds the
preset value, RTS/CTS scheme will be used to reduce collisions. Set it to a smaller value provided that there
are distant clients and interference.
4. DTIM Interval:
A DTIM (Delivery Traffic Indication Message) Interval is a countdown informing clients of
Содержание W301A
Страница 1: ...300M Wireless AP 1 ...
Страница 34: ...300M Wireless AP 34 5 Click OK ...
