54Mbps Wireless Long Range Wireless AP
Figure for hardware installation
Please pay attention to the following when installing hardware:
z
To connect the cable: Please connect the cable to the RJ45 port of the
TWL5401A properly, and then please tighten the cap.
z
To connect the Antenna: Please connect the antenna to the antenna
port of the TWL5401A properly and then tighten the cap
z
To install the Antenna: Please refer to the guide for installing Antenna
z
To have proper anti-water protection to all the ports connected, for
example, you could use Anti-water adhesive plaster to wrap the ports
connected
z
Please make sure that all the equipments are connected to the earth
properly, and please tighten the installation of TWL5401A on the
location
Warning: If you require to re-make the RJ45 connectors, please make use
that it is fully compliant with the TIA/EIA-568B international standard,
otherwise, if the RJ45 connectors are not made properly, it would cause the
wrong connection between the power cord and the data line, and this would
cause damages to the equipment. For all the results caused by the wrong
connection between cables or line, the end users or the installer should be
responsible for it.
4
