TEN
TEN Automotive Equipment Ltd.
©
Page 33
Version 5.0 November 2010
16 Maintenance
The INNOVA 3000 requires very little care and maintenance. It is recommended that surfaces are cleaned
periodically with a dry cloth and an automotive polish may be applied to painted surfaces. Use as directed by the
manufacturer of the cleaning/polishing agent.
The filters should be cleaned or replaced frequently. With normal to heavy use it is advisable to frequently check or
replace the fine filter and wash the pre-filter, in the drain separator.
To clean or replace the filters of the drain separator, please follow these steps:
Remove the transparent part of the drain separator by unscrewing it.
Remove the black plastic upper ring by unscrewing it.
Remove the fine filter (at the top).
Remove the intermediate ring.
Remove the washable pre-filter (at the bottom).
Clean or replace the filters and reassemble the drain separator.
Replace the plastic ring and transparent part of the drain separator by screwing it back on.
IMPORTANT!
Filter maintenance should be carried out frequently. Contaminated filters can cause problems with
the water drain system and subsequently cause serious damage to the internal Gasbench.
Always use original filters and never use filters which contain metal parts.
It is recommended that the fine filter is replaced when it is a dark grey colour or has become saturated with water.
The Pre-filter, In-line filter and Carbon filter should be replaced together, at the same time and depending on usage.
The monitor
Clean the monitor with a soft cloth. If necessary, use a mild spray detergent or glass cleaner. Never use solvents or
petrol. Never spray directly on the screen!
The INNOVA 3000 and Cabinet
Clean the cabinet with a soft cloth. Use a mild spray detergent, or household cleaner. Never use solvents, thinners
or petrol. Hinges can be lubricated with some drops of oil or grease
The Printer
Clean the printer with a soft cloth. If necessary, use a mild spray detergent or glass cleaner. Never use solvents or
petrol. Never spray directly on to the printer! Take care that no dust, dirt, grease or moisture enters the printer. To
change the ink, please follow up the printer manufacturer
’s instructions.
Cables and Sensors
Clean the Cables & Sensors with a soft cloth. If necessary, use a mild spray detergent. Never use solvents or
petrol. Frequently clean inside the jaws of the RPM Inductive clamp and check that the ferrite inserts are not
cracked or broken. If any cable or sensor is damaged, or broken, contact your supplier for replacement to avoid
subsequent damage to the INNOVA 3000.
