Ten-Tec SSB-CW-AM, Инструкция по эксплуатации

Страница: 65 / 135

Section 4C: IF Amplifier and AGC
4-50. Install U8, a MC1350P 8-pin DIP IC, being
the notched or dotted end as outlined on the board.
4-51. Install U9, a MC1350P 8-pin DIP IC, being
the notched or dotted end as outlined on the board.
4-52. Install transistor Q9, NPN type 2N4124.
4-53. Install transistor Q11, NPN type 2N4124.
4-54. Install transistor Q10, PNP type 2N5087.
4-55. Install diode D12, type 1N4148, with correct cathode
band orientation as outlined on the board.
4-56. Install the 455 kHz filter FL2 (labeled CFR455-I). Its pin
arrangement permits only one possible orientation. Simply ignore
the group of small circuit board holes covered by the filter case.
4-57. Install T2, a 455 kHz shielded transformer. Its pin
arrangement permits only one possible orientation. (While the
markings may vary, these transformers have 5 pins, 2 shield tabs
and are the only parts in the kit which will fit here.)
4-58. Install T3, a 455 kHz shielded transformer, per the
information in the preceding step.
Install the following 1/4-watt resistors:
4-59. Resistor R66, "0 ohm" (one black band).
4-60. Resistor R42, 100 ohms (brown-black-brown).
4-61 . Resistor R43, also 100 ohms.
4-62. Resistor R62, 1K (brown-black-red).
4-63. Resistor R67, also 1K.
4-64. Resistor R47, 2.2K (red-red-red).
4-65. Resistor R61, also 2.2K.
4-66. Resistor R52, 4.7K (yellow-violet-red).
4-67. Resistor R65, also 4.7K.
4-68. Resistor R50, 10K (brown-black-orange).
4-69. Resistor R51, also 10K.
4-70. Resistor R59, also 10K.
4-71 . Resistor R64, also 10K.
4-72. Resistor R63 , 22K (red-red-orange).
4-73. Resistor R49, 220K (red-red-yellow).
4-74. Resistor R48, 1 megohm (brown-black-green).
1254
±
Assembly - 44