Operation
Wireless Remote Control Programming
ONE WIRELESS REMOTE CONTROL AND TWO ERGO BASES
NOTE: The use of “Base A” and “Base B” is for
description purposes only and the beds will not
actually be labeled “Base A” or “Base B”.
STEP 1
Place four (4) AAA batteries into the Wireless Remote
Control A.
STEP 2
Store Wireless Remote Control B for future use.
STEP 3
Ensure the Ergo System bases are plugged into a
functioning outlet.
STEP 4
Locate the Emergency Power Down Boxes under both
Base A and Base B. Install two (2) new 9-volt batteries.
NOTE: Base A is already programmed upon
delivery.
STEP 5
Lightly press the learn button in Base B for three (3)
seconds.
STEP 6
When the Green LED light illuminates, press any
button on the wireless remote control.
NOTE: If a new signal is not received within 10
seconds, step 5 and step 6 must be repeated.
NOTE: The green LED light will blink once it
receives a remote signal. The bed will not
respond for 10 seconds during the remote
learn process.
STEP 7
When the Green LED light on the Emergency Power
Down Box turns off, you have completed the learning
process of the RF frequency code.
NOTE: The remote programming procedure may also
be performed using the learn button on the PLC.
Base A
Base B
Learn Button
15
Customer Service: 1–800–979–1457
