.09.
INSTRUCTION MANUAL
To fix the appliance with Cabinet, pls. screw the 3 screws (ST4.2*12mm) through the
Top Bracket. The Top Bracket is pre-installed on top of appliance.
ACCESSORY INSTALLATION BEFORE OPERATING
UNPACKING AND CLEANING THE WINE COOLER
•
Remove the exterior and interior packing materials.
•
Let the appliance stand upright for approximately
24 hours
before connecting
it to the power source, which helps to reduce the possibility of a cooling-system
malfunction from handling during transportation.
•
Use a soft cloth to clean the interior surface with lukewarm water.
I
MPORTANT: The front louver at the base of the appliance is for ventilation. Nothing
should be placed in front of this front louver; otherwise your Wine Cooler may not
operate properly.
o A decorative plinth can be fitted to the front of the base vent, a cut-out
should be made in the plinth with bigger size than the front louver. The
cut out is required whether the front louver is removed or not.
Adjusting the height and levelling off your wine cabinet
o The appliance is equipped with adjustable feet, so that the height may
be adjusted to level the cabinet on uneven floor surfaces.
o We recommend that two people carry out this procedure.
o The height must be adjusted prior to building the appliance into the
housing unit and it should be set at such a height that the top panel of
the appliance fits exactly below the kitchen worktop.
o Tilt the appliance approximately 60° to allow access
to the adjustable feet.
o Take care to ensure the cabinet is supported at all
times.
