12
Tempest MasterBelt Operating Manual
MasterBelt Power ON/OFF
•
The Power ON/OFF button is used to turn the MasterBelt ON or OFF.
•
Press and hold the Power ON/OFF button for two seconds to turn the MasterBelt
ON.
•
Press and hold for four seconds to turn the MasterBelt OFF.
Selecting a Frequency Band
The Tempest MasterBelt 2.4GHz model is approved for license-free use in most countries.
However, due to differences in radio spectrum regulations, a few countries require that 2.4GHz equipment limit or adjust its RF spectrum
operation. Always determine if there are country specific frequency restrictions that apply and select the required frequency band as described
below. Tempest performs RF frequency adjustment automatically when you select the appropriate frequency band from the “Tech Menu.” It is
only necessary to use this feature if you use Tempest in one of the countries with special frequency requirements. Otherwise, Band 1 should be
used for maximum RF performance.
If the Tempest Wireless system is transported to a country with special requirements, navigate to the Radio Configuration screen in the “Tech
Menu” to select the appropriate frequency band from the “Set Band” menu screen of the MasterBelt.
After changing the frequency band selection it is necessary to “pair” each BeltStation with the MasterBelt so the information can be transmitted
from the MasterBelt to the BeltStation. See the “Pairing BeltStations with MasterBelt” section of this manual for more information on pairing.
MHz
MHz
Avoid 802.11 b/g
Band
Start
End
Width
1
2400
2480
80
None
2
2400
2450
50
11
3
2423
2473
50
1
4
2431
2480
49
1, 2,
5
2400
2428
28
7, 8, 9, 10, 11
6
2423
2450
27
1, 11
7
2453
2480
27
1, 2, 3, 4, 5, 6, 7
2 sec
POWER ON
