4
Installation
Installation location depends on which features of the CM712 you are
using.
If you are using the internal temperature and humidity sensor,
located the CM712 in the area of interest away from direct
sunlight or air streams.
If you are using the external sensor(s), locate the CM712 con-
venient to power.
Connect any external temperature sensors, door sensors, or water
sensors purchased from
www.temperatureguard.com
. See wiring
diagram on page 12.
If you are providing your own SIM card
Turn the power off by sliding the power switch to the OFF position.
Remove the power jack.
Remove the four screws holding the cover on.
Insert the SIM card into the SIM slot.
Replace the cover, insert and tight the four screws.
Plug in the power jack.
Turn on the CM712 by sliding the power switch to the ON position.
The CM712 will power up and register itself on the cell network.
The green LED indicates the connection to the cellular network.
Steady blinking means that it is not registered on the net-
work.
Blinking on and then off for 2 seconds means that the
CM712 is registered on the network.
The Yellow LED indicates power and should be on.
The CM712 will now continuously cycle thru the status of all inputs.
